How to solve the insufficient momentum of the toilet after using it for a long time?

There are several reasons for the lack of flushing power, of course it may be related to the water pressure, there is a slight clogging of the toilet, which may also affect the flushing of the toilet, dirt has accumulated in the toilet tank, or the ceramic glaze of the toilet is not smooth.
Check method:
1. Check the water level of the water tank: If it is an old-fashioned toilet, open the toilet tank cover and observe the water level. Generally, the water level will be about 2/3. You can gently press down on the floating ball to see its flexibility and stuck phenomenon. If the up and down movement is normal, it is basically determined that the water level is normal. Furthermore, there may be water quality problems.
2. Test the momentum of the drain valve to find the drain valve, one side is full flush and the other is half flush. Find one of them to confirm whether it is full flush or half flush (full flush is about three centimeters from the bottom, half flush is about halfway). When testing, press the test once and wait for the water tank to stop filling, then press the second time. Of course, try a few more times to judge whether there is any big difference between the time of rushing at this time and the time of using the buttons normally. If there is a difference, then it is the problem of the case. Adjust the two screw rods of the toilet button, turn them out a few times, then put the lid on, try the button, feel the gap between them, and adjust the gap to about 2 or 3 mm. If it is not the problem of the button, then it is the drain valve, it is recommended to replace it.

Solution:
If the toilet itself is insufficiently pumped and the water pressure is insufficient, check whether the pipe is blocked, whether the slow water outlet of the water flow is blocked, and the water volume can be increased, such as putting a water bottle in the water tank, and then adjusting the screw rod of the water inlet valve Let the water level rise, but pay attention to it, and pay attention to at least 10mm away from the overflow pipe of the drain valve. It is also possible that the inside of the water pipe is stained with dirt due to long-term use. You can pour Coke into the toilet and let it stand for about one night. The principle is that the carbonic acid dissolves the urine alkali and water alkali, rinse it off the next day, and then rinse it with clean water.